WeatherRoof III – WRIII
Description: A metal standing seam roofing product attached to sub-framing using a variety of concealed, interlocking clips that provide for minimum panel penetrations. This panel can be used on new construction as well as retro-fit on existing structures. This panel design provides a high degree of weather tightness and has been tested by independent laboratories in accordance with ASTM E283 and E331 (for air infiltration, water penetration, and wind uplift).
Gauge: 24 and 22 (by special request only)
Lengths: 50′ maximum is standard but longer lengths available by special request.
Fasteners: Concealed fastening system. The clips are available as floating or fixed. Two different clip heights are available to allow for thermal blocks.
Finish: Galvalume and “Architectural Series”
Manufactured: Houston, Caryville, Mattoon, Rome, Salt Lake City & Atwater
Usage: New and retro fit applications.
Limitations: Recommended for roof slopes of 1/4:12 or greater. When using the fixed clip we recommend for double slope buildings 200′ wide or less and single slope buildings 100′ wide or less. (May vary upon extreme weather conditions.) Oil-canning is not a reason for rejection.
|1. No panel penetration is required over the building envelope other than at the end laps, and panel ends which are connected by a compression joint.||1. Specially designed to seal out the elements.|
|2. Panel side laps arrive at the job site containing a pre-applied sealant.||2. Contributes to the system’s weather tight construction and ease of erection.|
|3. Optional product and weather tightness warranties||3. Severe weather tightness and additional customer confidence.|
|4. Factory notched at both ends with pre-punched holes||4. Field installation can commence or finish from either end of building or on both sides simultaneously.|
|5. End laps have a 16 ga. backup plate with pre-punched holes||5. Solid connection at end laps and proper fastener spacing. The pre-punched holes improve erection and ensures proper panel placement.|
|6. High or low clips||6. Accommodates variety of insulation systems including 1″ thermal spacers at the purlins|
|7. UL 90||7. Lower insurance costs|
|8. 80% less exposed fasteners than traditional side lap panels and all fasteners are long life.||8. Increased weather tightness|
|9. Panel available Royal K-70 paint system||9. 20 year finish warranty|
|10. The side lap has been tested for air infiltration and water penetration under ASTM E283 and E331 methods||10. Minimal air infiltration and water penetration and acceptability among specifiers.|